After creating a course you are ready to start a session and begin polling. Once polling is started, students can begin answering your polling questions with their i>clicker remotes.
![]() |
NOTE: If any of your students are using i>clicker GO (mobile clickers) in your class, you must enable i>clicker GO before you begin polling (see i>clicker GO Settings for setup instructions). |
![]() |
NOTE: If you are using a base receiver running v3.03 firmware or earlier, only A-E questions are supported and the drop-down menu will not appear. |
![]() |
NOTE: If students vote when polling is inactive, the Vote Status light on their remotes will flash red three times to indicate their votes were not received (i>clicker remote) or they will see a CLOSED message on their LCD (i>clicker2 remote). |
![]() |
TIP: If you use presentation software to display your questions (e.g., PowerPoint or Keynote), make sure it's the active application when you start polling by clicking on the presentation window. Each time polling begins, i>clicker captures a screenshot of the active window and stores it along with polling results for later review in i>grader. |
![]() |
TIP: You can use an instructor's remote to control polling from anywhere in the room. (See Instructor's Remote ID in General Settings.) |